IGT 37 mbar Propane Bottle Gas Regulator with Gauge

IGT 37 mbar Propane Bottle Gas Regulator with Gauge - UK POL mount

The propane gas regulator is one of the most important parts of a propane gas system. The purpose of the regulator is to control the flow of gas and lower the pressure from the tank to the appliance(s) in the gas system. The regulator not only acts as a control regarding the flow and distribution of propane but also as a safety barrier between the high pressure of the tank and the end use appliance(s). 

Suitable output hose: https://lpgshop.co.uk/8mm-orange-high-pressure-gas-hose-per-meter/ 

Conditions and Instructions before use:

1. Fitting and operating conditions

- The A310i I A300i is a household regulator designed IO supply gas to gas consuming

Appliances at a pressure and capacity as indicated on the identification label (1).

- The A310 I A300i can be fitted to any cylinder equipped wi1h a cylinder valve wilt hand closure (9). -The gas cylinder must always be used in the upright position.

- Whenever used outdoors, the A310i I A300i must be suitably protected against rain.

- Never look for leaks using a flame, just use a soapy-water solution.

- In case of any difficulties or problems, shut off the gas supply and contact your dealer

Immediately.

- Should a leak catch fire prematurely before you can close the cylinder valve (2) then, use a wet cloth to close the cylinder valve.

2. Mounting the connection to the gas consuming appliance in execution with hose nozzle outlet

Fit a regulation rubber hose (J) to the nose nozzle (lubricate the latter with water to facilitate the insertion). To guarantee a sound connection use a regulation hose clip (4) which is usually-sold together with the hose and is in any case adapted to the hose dimensions.

3. Assembly on the gas cylinder make sure that:

- All taps on the consuming appliance are closed

- The connecting pipe to the gas appliance is correctly fitted.

In total absence of any name remove the plug or seal cap from the cylinder valve. After checking the presence and the good state of the gasket (8), tighten the union nut (9). By screwing up in the direction indicated by the arrow (10). The union nut should be tightened moderately. Nevertheless sufficiently to ensure a leak-tight-joint which must be checked by using a soapy-water solution. Hold the regulator and turn the union nut. The regulator itself is never to be rotated.

4. Plant Operation

Once the AJ10i /A300i has been correctly mounted on cylinder valve the gas supply occurs by turning the valve hand-wheel in the direction shown by the arrow (11). To shut off the gas supply reverse above procedure.

5. Replacing the Gas Cylinder  

Make sure that:

- All taps on the consuming appliance are in the closed position.

- The cylinder valve is closed.

Then dismount the A310i I A300i by unscrewing the union nut (9).